AR400 vs carbide: cost per hour of use
On a cost-per-hour basis, AR400 typically wins where abrasive wear is moderate and blade changes are cheap; carbide wins where downtime and…
Read the guide
Winter prep for polar vortex: edge checks
Check cutting edges before the first polar vortex forecast, not after the first breakdown. A cold-weather edge inspection covers three things: wear…
Read the guide
Why your plow chatters
Plow chatter is almost always a stiffness or compliance problem somewhere in the blade–edge–surface loop, not a blade angle problem alone. The…
Read the guide
Telehandler edges on paved lot: what changes
On a paved lot, a telehandler bucket or pusher edge is not really a snow-plow edge. Paved surfaces change the wear mode:…
Read the guide
How distributors should qualify a snow pusher edges factory
Qualifying a snow pusher edges factory means verifying four things before price: the steel grade and its mill certificate, the heat-treatment record,…
Read the guide
Buyers aftermarket edges: poly versus carbide
Poly edges suit light-duty and municipal fleets that prioritize pavement protection and low noise; carbide edges suit high-volume operations that need maximum…
Read the guide
Freight rates: reading them for edge budgets
Freight is a per-shipment cost that lands on every cutting edge you buy, and for a dense steel item it can move…
Read the guide
Plow cameras and your edges
Plow cameras change how cutting edges wear, and that changes what you should stock. A camera system that keeps the operator’s blade…
Read the guide
Vendor scorecards for fleet managers
Use a vendor scorecard to convert snow plow cutting edge sourcing from a price comparison into a repeatable evaluation of wear consistency,…
Read the guide
Toughness versus hardness: what it means for edge buyers
Toughness and hardness are opposing properties in a cutting edge, and the right balance depends on what the blade hits. Hardness resists…
Read the guide