How to size a reversible edge for a UTV plow
Size a reversible edge for a UTV plow by matching three dimensions to the mouldboard: overall length, hole spacing and offset, and…
Read the guide
How to size a weld-on edge for a pickup plow
Size a weld-on edge from the mouldboard’s lower lip and the existing hole pattern, not from the nominal blade width. Measure the…
Read the guide
How to size a serrated edge for a truck plow
Size a serrated edge from the mouldboard geometry, the existing bolt pattern and the plow’s trip or down-pressure behaviour — not from…
Read the guide
Motor grader edges on chip seal: what changes
Chip seal changes the wear mode, not the mounting pattern. A motor grader edge that works on gravel will still bolt up,…
Read the guide
How to size a two-piece edge for a motor grader
Size a two-piece motor grader edge by matching each half to the mouldboard end it bolts to: measure the mouldboard’s true length…
Read the guide
Yard loader edges on asphalt: what changes
Yard loader edges on asphalt change the wear mode from scraping to impact-plus-abrasion, so the edge material, thickness and bolt pattern matter…
Read the guide
UTV plow edges on paved lot: what changes
On a paved lot, a UTV plow edge behaves less like a wear part and more like a controlled contact interface: the…
Read the guide
Wheel loader edges on paved lot: what changes
Wheel loader edges on a paved lot change the wear mode first and the specification second: the cutting edge stops digging and…
Read the guide
What to record for sidewalk machine edge wear
Record four things at every edge change: measured wear (thickness loss and remaining height), wear pattern (location and asymmetry), mounting condition (bolt…
Read the guide
Backhoe edges on concrete with joints: what changes
Concrete with joints changes the load case, not just the wear rate. A backhoe edge that runs a clean slab sees mostly…
Read the guide