An inspection photo shows a gauge reading but no part identity. Can we use it?
Assess an unlabelled gauge photo by requesting a linked sequence of part identity, feature, method and result before using it for blade…
Read the guide
How should we record a measurement that sits very close to the drawing limit?
Handle blade readings near a tolerance limit with an agreed decision rule, suitable measurement method and preserved raw results instead of convenient…
Read the guide
Can we reuse last year’s test certificate for a repeat blade order?
Check whether an older blade certificate actually covers new material, separating repeat-order qualification data from order-specific acceptance evidence.
Read the guide
A factory sample fits, but our receiving sample does not. How should the two be compared?
Compare factory and receiving fit samples by identity, revision, interface and method before attributing a blade mismatch to production or transport.
Read the guide
We only need part of a batch urgently. Can those blades be released separately?
Plan a traceable partial release of urgent blades with a defined sublot, applicable evidence and separate stock status for the unreleased remainder.
Read the guide
Can the supplier replace failed samples and then call the original lot accepted?
Preserve failed sample results and use an agreed screening or resubmission process instead of replacing failed pieces to create an apparent passing…
Read the guide
Our acceptance report says pass but contains no measured values. Is it sufficient?
Check whether a pass-only blade report meets the ordered evidence requirements and request linked readings where quantitative results were specified.
Read the guide
What should we do if an inspection instrument’s calibration has expired?
Assess blade measurements made with an overdue calibration status by identifying affected decisions and arranging qualified review without erasing results.
Read the guide
A delivery has cosmetic scratches. How do we decide whether they are an acceptance issue?
Classify blade scratches by location and agreed requirements, distinguishing appearance from possible functional damage before an authorized disposition.
Read the guide
Should the approved sample travel back and forth between buyer and factory?
Protect an approved blade sample as a controlled reference with custody, condition records and agreed matched alternatives before sending it between sites.
Read the guide