Is a video call enough for a remote blade acceptance inspection?
Scope a remote blade inspection around observable checks, identified samples and retained records, with separate decisions for evidence a video cannot show.
Read the guide
The inspection report uses a different drawing revision from the order. What should happen next?
Resolve an inspection report tied to the wrong drawing revision by mapping changed features and obtaining applicable evidence without rewriting history.
Read the guide
Can we combine several production lots into one incoming inspection sample?
Define the inspection population before combining blade lots, retaining material, process and revision boundaries for an authorized sampling decision.
Read the guide
One item fails in an otherwise acceptable sample. Does the whole lot have to be rejected?
Separate a failed blade sample from the lot decision, check the agreed acceptance rule, and preserve evidence before arranging any further inspection.
Read the guide
Our inspected samples were taken only from the top of the pallet. Is that enough?
Review top-of-pallet blade sampling against the agreed selection plan and arrange access to unrepresented stock before relying on a lot decision.
Read the guide
The sample has no lot number. Can its test results support the bulk order?
Decide whether an unmarked sample supports a bulk blade order by reconstructing identity, separating capability evidence and requesting traceable tests.
Read the guide
Can we accept a blade shipment while one required test report is still missing?
Keep receipt, inspection and release separate when a blade test report is missing, with lot-specific holds and an authorized documented disposition.
Read the guide
A batch passes the fit gauge but fails our dimensional report. How should we resolve the disagreement?
Resolve conflicting fit-gauge and dimensional results by checking revision, datum, method and decision rules before releasing the disputed blade lot.
Read the guide
The pre-production sample was hand-finished. What should we verify before accepting machine-produced blades?
Check which sample features were hand-finished, request production-representative evidence, and define what approval covers before releasing blades.
Read the guide
A test certificate cites an old standard edition. What should we do before accepting it?
Compare an older test-standard citation with the order, assess relevant method differences and document equivalence or request the required test.
Read the guide