Does a Fisher-style edge fit a Sno-Way mount?
Not as a direct bolt-on, in most cases. A Fisher-style cutting edge and a Sno-Way mount share the general idea — a…
Read the guide
Cobalt policy: reading them for edge budgets
Cobalt policy in a cutting edge specification is a purchasing control, not a metallurgical preference: it sets how much cobalt-bearing alloy you…
Read the guide
Deicers and your edges
Deicers do not attack your cutting edges directly; they change the conditions the edge works in. Salt, brine and other chloride-based products…
Read the guide
Bid documents: a one-page template
Bid documents for snow plow cutting edges work best as a single controlled page that fixes the specification, the acceptance criteria and…
Read the guide
Binder content: questions to ask a supplier
Binder content in a snow plow cutting edge is the percentage of the total cross-section occupied by the steel matrix that holds…
Read the guide
Truck plow in blowing snow: edge choices
In blowing snow, the edge choice that holds up best is usually a through-hardened carbon steel base edge with a bolt-on carbide…
Read the guide
Truck plow edges at a HOA road
A truck plow edge for HOA road maintenance should be specified by the road surface, the plow’s down-pressure, and the number of…
Read the guide
AD/CVD scope: documents to keep
For an AD/CVD scope review, keep the documents that tie a specific cutting edge to a specific mill heat and a specific…
Read the guide
When to replace rather than flip a UTV plow edge
Replace rather than flip a UTV plow edge when the wear indicator or base metal is compromised, when the bolt holes or…
Read the guide
Storing spare edges: moisture
Store spare cutting edges indoors on a dry, ventilated rack, off the floor, with edges separated so air can move across every…
Read the guide