Skip to content
Carbide snow plow blades, inserts and wear parts — engineered in Rayong, Thailand
Request a Quote
SENTHAI knowledge base

SENTHAI Knowledge Base

Field notes, specification help and wear data from the engineers who press, sinter and weld our carbide edges in Rayong.

  • Airports
  • Application
  • Blade Selection & Specification
  • Commercial & Parking Lots
Carbide snow plow blades stacked in the SENTHAI factory for the knowledge base
Our route crosses decorative paving. What should we ask before trying a carbide edge? Talk Our route crosses decorative paving. What should we ask before trying a carbide edge? Before a carbide-edge trial on decorative paving, confirm owner restrictions, surface condition, acceptable finish and damage stop criteria. Read the guide Should we order replacement fasteners by the old bolt’s measured length? Talk Should we order replacement fasteners by the old bolt’s measured length? Order blade fasteners from the approved hardware specification and mounting stack, rather than copying the measured length of a worn bolt. Read the guide The plow has no readable model plate. What can we establish before requesting a replacement edge? Talk The plow has no readable model plate. What can we establish before requesting a replacement edge? Build an identification pack for a plow with an unreadable plate, while keeping model identity and replacement compatibility explicitly unresolved. Read the guide Can a scan of an old blade replace an approved manufacturing drawing? Talk Can a scan of an old blade replace an approved manufacturing drawing? Use an old-blade scan as condition evidence, then distinguish wear and reconstructed geometry before approving a manufacturing drawing. Read the guide What should a supplier see in a section drawing of a rubber-flex blade clamp? Talk What should a supplier see in a section drawing of a rubber-flex blade clamp? Define a rubber-flex segment with a clamp section, retained interfaces and approved orientation; keep segment supply separate from assembly approval. Read the guide The new edge touches a curb guard before it seats. Is trimming it an acceptable fix? Talk The new edge touches a curb guard before it seats. Is trimming it an acceptable fix? Stop a blade fit that contacts the curb guard. Compare end geometry and kit contents, then obtain corrected parts or an authorized… Read the guide How should we record a hole pattern that repeats except at one joint? Fitment & Brands How should we record a hole pattern that repeats except at one joint? Document an exceptional hole spacing with numbered centres, a common datum and an explicit joint detail so repeated-pitch notes cannot hide it. Read the guide Our blade is reversible on paper. How can we confirm that both orientations are approved? Talk Our blade is reversible on paper. How can we confirm that both orientations are approved? Confirm reversible cutting-edge approval with two installed views, working-feature orientation, fastening details and applicable wear instructions. Read the guide Can we replace a two-piece cutting edge with one continuous blade? Talk Can we replace a two-piece cutting edge with one continuous blade? Treat a two-piece-to-one-piece cutting-edge change as a conversion. Review joints, movement, mounting and installation before approval. Read the guide The part number was superseded. What should we verify before ordering the new edge? Talk The part number was superseded. What should we verify before ordering the new edge? Verify an edge part-number supersession against model applicability and companion-part changes before updating an order or fleet cross-reference. Read the guide

Send us a blade drawing and get a quote back

Tell us the machine, the material you are clearing and the wear life you need. Our engineers reply with the edge profile, carbide grade and packing that fit the job — usually within one working day.